Guide Ramp heating

Ramp heating

What to say when you review heating cables on a ramp before the topping is placed.

Red heating cables laid in a serpentine pattern on reinforcing mesh on a garage ramp before the concrete topping

Say it like this

Talk the way you would to a colleague on site. Below each recording is the note Neuveria writes from it. You review and edit every note before the report goes out.

Cable layout

You say

“Garage ramp, heating cables are laid out on the mesh in a serpentine, about nine inches apart, tied every two feet or so. Two zones, the feed is at the top of the ramp by the wall. The electrician did a resistance test this morning and the readings are posted on the panel.”

Neuveria writes

At the garage ramp, the heating cables were laid out on the mesh in a serpentine pattern, approximately 230 mm (9") apart, and tied at approximately 0.61 m (2'-0") intervals. Two zones were provided, with the feed located at the top of the ramp adjacent to the wall. The electrician conducted a resistance test in the morning, and the readings were posted on the panel.

Cable on the membrane

You say

“Near the trench drain the cable crosses over itself in one spot, and in another it's sitting right on the membrane for about three feet with no chairs. This is outstanding. Contractor to fix the crossing and get the cable up to mid-depth of the topping before the pour.”

Neuveria writesOutstanding

Near the trench drain, the cable was observed crossing over itself at one location. At another location, it was resting directly on the membrane for approximately 0.91 m (3'-0") without chairs. This work remains outstanding. The contractor is to correct the crossing and raise the cable to the mid-depth of the topping before the concrete pour.

See it with your own projects

A 20-minute call where we walk through a real report from start to finish, or watch the 13-minute video first.

Book a demo