Guide Damp-proofing

Damp-proofing

What to say when you review damp-proofing on foundation walls before backfill.

Bituminous damp-proofing applied to exterior concrete foundation walls in winter

Say it like this

Talk the way you would to a colleague on site. Below each recording is the note Neuveria writes from it. You review and edit every note before the report goes out.

Coverage

You say

“East and north foundation walls, damp-proofing is on from the footing up to about six inches below the top of wall. Two coats, looks even, no pinholes. It's about minus five so they're using the winter grade product, the cans are on site.”

Neuveria writes

Damp-proofing was applied to the east and north foundation walls from the footing to approximately 150 mm (6") below the top of the walls. Two coats were applied, with an even appearance and no pinholes observed. The temperature was approximately -5°C (23°F), and the contractor was using the winter-grade product. The product containers were on site.

Bare spots

You say

“West wall, there are bare spots at the tie holes, maybe ten of them, and the coating stops about a foot short of the footing at the corner by the stairs. This is outstanding. Contractor to touch it up before backfill, we'll look again on Thursday.”

Neuveria writesOutstanding

Approximately ten bare spots were observed at the tie holes on the west wall. At the corner adjacent to the stairs, the coating terminated approximately 0.30 m (1'-0") short of the footing. This work remains outstanding. The contractor is to touch up the coating before backfilling. We will review the work again on Thursday.

See it with your own projects

A 20-minute call where we walk through a real report from start to finish, or watch the 13-minute video first.

Book a demo